Resin Fun To Do Snow White NxtGen (White) 1L

Snow White Nxt Gen resin when freshly printed has a certain yellow tone, but the yellow tone disappears when it is fully cured in the curing unit and once cured it turns white.

Snow White resin is the ideal resin for those of you who are looking to give great visual realism to your prints, by default you will print your pieces in a pristine white ideal for architectural models or even teeth (product indicated for dental technicians) but you will also have the opportunity to mix the resin with one of the four available pigments (blue, black, red and yellow) to obtain the desired shade and colour of your paints.

Once fully cured, the resin has a shore hardness of 80D.

With Fun To Do’s Snow White resin all your printed objects will have a very high resolution and will look like they just came out of an injection mould. The maximum shrinkage of your printed objects will be only 0.5%.

This resin is ideal for use with the Fun To Do pigment set.

Recommended parameters

Layer height (mm): 0.08
Number of base coats: 4 – 8
Exposure time base coats (sec): 65
Exposure time other layers (sec): 11 – 11.5

Characteristics

The resin is composed of:

• Photo initiator
• Monomer
• Photo inhibitor

The photo initiator, when exposed to UV light, causes the monomer to cure.

The photo inhibitor prevents the UV light from curing excessively.

The perfect match between the UV dwell time and the percentage of photo initiator and the percentage of photo inhibitor makes it possible to work with the desired layer height.

Fun To Do resin cures in 2 to 4 seconds with a layer height of 75 microns (0.075mm), if a DLP projector between 2500 and 3000 lumens is used.

However, curing times may vary depending on the printing configuration (layer height, resin colour, distance between projector and resin…).

Storage Recommendations

• Keep in a cool and dry place. Shelf life is approximately 1 year, if stored under optimal conditions. The recommended storage temperature is between 10ºC and 25ºC.
• Caution: Excessive heat will prematurely polymerise the resin.
• Resin left over from one impression can be used in future impressions.

 

Recommendations Once the impression has been made

• Give the piece a bath in isopropyl alcohol (approximately 2-4 minutes) and remove it to remove resin residues.
• Clean any isopropyl alcohol residue from the piece after the bath, you can use a hairdryer or compressed air, but do not use hot air.
• Leave in the sun for 20 to 40 minutes, or expose to ultraviolet light for 1 to 8 minutes (depending on the piece).

Fun To Do Resin Characteristics

• Cure speed: Fast with UV lamps.
• Storage: Cool, dry and out of direct light.
• Dimensions: 26x10x10 cm
• Contents: 1L

Weight	1.2 kg
Dimensions	26 × 10 × 10 cm
Resin Type	DLP
RESIN - COLOUR	White
Brand	Fun To Do
RESIN FEATURES	Dental, Standard
Capacity	1L