Resin Fun To Do Dentifix 3D Gingiva Dental HR

Fun To Do Dentifix 3D Resin is specially created for the fabrication of gum models. This resin has been created with the collaboration of experts in the dental sector.

It is a strong and flexible resin, designed for the impression of flexible gingival masks that simulate the flexibility of the gums, to fit dental prostheses.

It can be used in conjunction with Dentifix 3D resin for dental moulds.

Features

The resin is composed of:

• Photo initiator
• Monomer
• Photo inhibitor

The photo initiator, when exposed to UV light, causes the monomer to cure.

The photo inhibitor prevents the UV light from curing excessively.

The perfect match between the UV dwell time and the percentage of photo initiator and the percentage of photo inhibitor makes it possible to work with the desired layer height.

Fun To Do resin cures in 2 to 4 seconds with a layer height of 75 microns (0.075mm), if a DLP projector between 2500 and 3000 lumens is used.

However, curing times may vary depending on the printing configuration (layer height, resin colour, distance between projector and resin…).

Storage Recommendations

Keep in a cool and dry place. Shelf life is approximately 1 year, if stored under optimal conditions. The recommended storage temperature is between 10ºC and 25ºC.

Caution: Excessive heat will prematurely polymerise the resin.

Resin left over from one impression can be used in future impressions.

Recommendations Once the impression has been made

Give the piece a bath in isopropyl alcohol (approximately 2-4 minutes) and remove it to remove resin residues.
Clean any remaining isopropyl alcohol from the piece once the bath has been done, you can use a hairdryer or compressed air, but do not use hot air.
Leave in the sun for 20 to 40 minutes, or expose to ultraviolet light for 1 to 8 minutes (depending on the piece).

Recommended parameters

• Coating height: 0.05 mm
• Number of base coats: 8
• Off time: 2
• Exposure time base coats: 90 secs
• Exposure time other layers: 15 secs

Fun To Do Dentifix 3D Resin Characteristics

• Curing speed: Fast with UV lamps.
• Storage: Cool, dry and out of direct light.
• Dimensions: 26x10x10 cm
• Contents: 1000 mL

Weight	1.2 kg
Dimensions	26 × 10 × 10 cm
Resin Type	DLP
Brand	Fun To Do
RESIN FEATURES	Dental
Capacity	0.25 L, 1L