Resin Fun To Do Standard Blend Red 1L

Fun To Do Standard Blend Red Resin is a multi-purpose resin with which you can efficiently and economically test your designs and prototypes.

Once fully cured, the resin has a shore hardness of 35D.

Features

The resin is composed of:

• Photo initiator
• Monomer
• Photo inhibitor

The photo initiator, when exposed to UV light, causes the monomer to cure.

The photo inhibitor prevents the UV light from curing excessively.

The perfect match between the UV dwell time and the percentage of photo initiator and the percentage of photo inhibitor makes it possible to work with the desired layer height.

Fun To Do resin cures in 2 to 4 seconds with a layer height of 75 microns (0.075mm), if a DLP projector between 2500 and 3000 lumens is used.

However, curing times may vary depending on the printing configuration (layer height, resin colour, distance between projector and resin…).

Hardness

Shore hardness of Fun to Do Standard Resins – 35D (approximately equivalent to a shore hardness rating of 88-90A).

Storage Recommendations

Keep in a cool, dry place. Shelf life is approximately 1 year, if stored under optimal conditions. Recommended storage temperature is between 10ºC and 25ºC.

Caution: Excessive heat will prematurely polymerise the resin.

Resin left over from one impression can be used in future impressions.

Recommendations Once the impression has been made

• Give the piece a bath in isopropyl alcohol (approximately 2-4 minutes) and remove it to remove resin residues.
• Clean any remaining isopropyl alcohol from the piece once the bath has been done, you can use a hairdryer or compressed air, but do not use hot air.
• Leave in the sun for 20 to 40 minutes, or expose to ultraviolet light for 1 to 8 minutes (depending on the piece).

Fun To Do Resin Characteristics

• Cure speed: Fast with UV lamps.
• Storage: Cool, dry and out of direct light.
• Dimensions: 26x10x10 cm
• Contents: 1L